BRADY BBP11-24L DRIVER DOWNLOAD
User’s Manual Label Printer. If it is not lit on, power supply is broken. Plug in the SD card on main board. Please follow the steps below to calibrate the sensor. It calibrates the sensor and measures the label length and prints internal settings then enter the dump mode. In the dump mode, all characters will be printed in 2 columns as following. BBP11 User Manual 1.
|Date Added:||11 January 2009|
|File Size:||48.28 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
These limits are designed More information.
Brady BBP11 300 dpi printer – English version – 240V
Setting up the printer 3 2. Plug in the SD card on main board.
Media view window 4. Press down the media holder lock switch to fix the media holder.
No part of this document may be photocopied, reproduced, or translated to another language without the. Red with blinking Error The out of label or ribbon or the printer setting is not correct 1. And place the paper, printing side face up, through the media sensor and place the label leading edge onto the platen roller. Make sure the power switch is off. Operation is subject to the following two conditions: Release the button when LED indicates with different color for different functions.
BBP11 Programming Manual – English – Brady Europe
The LED color will be changed as following: Set black mark sensor as media Release sensor and calibrate the black mark sensor 5. Run printer self-test and check the print head test pattern if there is dot missing in the pattern. Although the printer takes only a small amount of space, it delivers reliable, superior performance.
Power jack socket 6.
This printer provides both thermal transfer and direct thermal printing at user selectable speed of: This printer provides both thermal transfer and direct thermal printing at user selectable speed of: This equipment has been tested and founded to comply with the limits for a Class A digital device pursuant to Part More information. Peel-off roller Backing paper opening 7.
This equipment has been tested and founded to comply with the limits for a Class A digital device pursuant to Part. Peeling will automatically start. Configure the IP, subnet mask and gateway. Open the printer top cover by pulling the green tabs located on each side towards the front of the printer, then lift the top cover to the maximum open angle.
Open the peel-off panel by pulling it out.
BBP11 Label Printer
BBP11 User Manual 9. Set gap sensor as media sensor and Release calibrate the gap sensor 6. LED and Button Functions Poor Print Quality Top cover is not closed properly.
The copyrights in this manual and the label printer described therein are owned by Zebra Technologies. No print on the label gateway. User s Manual 3.
Printer status can be easily shown on the Diagnostic Tool. Gently close the top cover. To calibrate gap or black mark sensor, depends on the sensor setting in the last print job. Regularly clean the print head and supply sensors once change a new ribbon to keep printer performance and extend printer life.